FAQ

How to calibrate a Hoverboard
Step 1: IMPORTANT! The SmartScooter must be switched off for charging. Step 2: Keep the iconBIT Smart Scooter straight and make sure that both half are on ...
Wed, 1 May, 2019 at 12:28 PM
Change driving modes at the TT
The device has 2 different modes zero-start-mode and non-zero-start-mode. Zero-start-mode means: You press the throttle and the device starts Non-zero-...
Wed, 1 May, 2019 at 11:42 AM
Change maximum speed at the TT
The device has 2 settings for maximum speed. To switch between the two speeds, press the on / off button twice in quick succession, the last blue LED will ...
Wed, 1 May, 2019 at 11:42 AM
Remote control doesn't work - Scooter S
Possible problem: You have been pressing power button on the device for too long time (over 5 seconds) and your RC was unlinked from Scooter S. Recovery ste...
Wed, 1 May, 2019 at 11:42 AM
Calibrate Smart Scooter S
Please watch the video on the link below: https://scooterservice.eu/uploads/scooter_s_cal.mp4
Wed, 1 May, 2019 at 11:43 AM
Remove the battery on a K9 e-bike
To remove the battery: 1. Insert the key and move the key to the off position 2. Push the key down and at the same time turn to the unlock position 3. Re...
Wed, 1 May, 2019 at 12:06 PM
How do you charge a hoverboard correctly?
Step 1: IMPORTANT! The SmartScooter must be switched off for charging. The supplied power supply starts the charging process only when the scooter is switch...
Wed, 1 May, 2019 at 4:43 PM